Forgot your password? Reset It

Sand for Censer - Desert tone

Only 3 left!

Natural light colored sand especially selected and packaged for use in incense censers. Fine small grain sand will hold cones and sticks and works as a heat absorbing "base" for charcoal tablets. Comes in a 5.5-ounce bag from "Incense Sampler".
This type and color is called "Desert Sand"

A really good idea for incense lovers, nice clean look for any censer. Helps heat absorption and air circulation around charcoal and incense

"Heating" Incense Over Smoldering Charcoal with Sand and/or Ash-

(for Kyphi or premium resins blends and precious woods)

With this method of burning incense, you'll actually be "heating" the incense, not smolder it directly on the charcoal. This method of burning incense is especially good for aromatic wood chips.
Fill a heatproof incense bowl or censer with at least 2" of sand, or natural ash. This will provide some much-needed insulation for your burner. Charcoal can burn at up to 1500 degrees F.
If you filled your burner with sand (instead of ash) form a cone shape so that you can place the charcoal tablet at the peak. This will allow air to flow around the charcoal.

Place a charcoal tablet on the ash/sand and light the edge. If it's self-igniting charcoal you will see tiny sparks as you light it and it will ignite quickly so never hold it in your hand! If you need to hold the charcoal over an open flame to ignite it, use tweezers, chopsticks or tongs to hold it.

Wait until the charcoal is glowing red hot and is covered with grayish-white ash. This will take about 5 minutes or so. If you like you can fan or blow on the charcoal to help get the whole tablet started.

If you're using ash, cover the charcoal with a thin layer of ash. If you're using sand, loosely cover the charcoal with a small piece of aluminum foil (you can even make a small foil cup). Making sure the charcoal has enough air flow at the top so it doesn’t go out. Sand doesn't allow the charcoal to breathe like ash does.

Place your incense directly over or next to the ash-covered charcoal. If using sand, place it on the foil.

The charcoal will stay hot enough to burn incense for about 45 minutes to an hour.

Burning Tips:

· If using wood chips they should be approximately ¼" wide or the size of a grain of rice. · Resins can melt. If you're using aluminum foil cup to burn them never pick up the cup until it is cool. You can get a serious burn from the hot liquid!

People who purchased this also purchased...

Only 3 left!